APRILIA QUASAR 180 Manual de Serviço descarregar pdf (Página 94)

QUASAR 125-180

ENGINE

- 45 - 00

Release 00/2003 - 09

1 2

5 4

3.7.4 REFITTING THE CRANKCASE

Grease oil seals and oil bearings to prevent crankshaft (1) from being

scored and to make assembly operation easier.

" Heat the left casing with an automatic heater up to about 150°C (~ 10

minutes).

" To fit crankshaft (1) to left casing (2), install valve drive chain.

" Heat up right casing, as previously described for the left one, and fit it to

crankshaft.

" Tighten retaining screw (3).

To carry out the following operations, work on engine left side.

" Install kick-start pedal gear (4), with the chamfered edge facing downwards,

onto crankshaft.

" Refit lower chain sliding shoe (5) and secure it in place with screw (6).

" Refit kick-start pedal system, see 3.6.2 (REFITTING THE STARTING

SYSTEM).

To carry out the following operations, work on engine right side.

" Refit gear and pump drive chain, see 3.4.3 (REFITTING THE OIL PUMP).

" Refit the electric starting system, see 3.6.2 (REFITTING THE STARTING

SYSTEM).

" Refit the piston, see 3.2.28 (REFITTING THE PISTON).

Once finished, check for crankshaft (1) correct positioning. It shall be free to

turn without any jamming.

NOTE If needed, restore axial play with a mallet.

Do not use any metal mallet, but a rubber or plastic mallet. Never tap

directly on the crankshaft.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 167 168

Sem comentários

APRILIA QUASAR 180 Manual de Serviço Página 94